Most of us do one of these 5 mistakes thatll kill your headphones before their expected due date:
Carelessly rolling over the cord:
Most headphones come with extraordinarily long cords. Generally, the cord length varies amongst 7 to 10 toes. And it is clear that you dont let your cords hang out on the grounds alternatively you coiled it up around your headset which is also not just right. If by chance, the coils are out on the ground to take care that nobody step on it or worse rolled over by the casters on your pc chair. It just takes a single severed point to make it completely vain. Letting the cord dangle off the edges of your workstation is another way of damaging your headphones.
Winding the cords into the knots:
Are you also following the ones imaginitive ways of winding up the cords so that they dont tangle within. Well, you must avoid them. Since they involve tight loops and knots that damage the internal wiring of your delicate headphone set. So never tie knots, avoid the tight loops and retain it free.
Traveling without a case:
One of the most typical mistakes that of us make is that they toss the earphones in their pockets, backpacks, purses and forget that. The cord is stretched, pulled, twisted, bent, pinched, crushed and ultimately damaged. So whenever possible use a case to retain your headphones safe.
Exposing it to moisture:
Water and electronics can not go together. Just as water can fry your mobile phones and laptops, water when going into the headphones, it can fry the entire electronics within. Similarly, sweat can also be a amazing problem. So if you'll have the habit of listening to music while training, then drop it both go for waterproof devices to buy. Or at the least avoid using your headphones in rains and directly out of the shower.
Pulling the cord, not the plug:
Remember, tension on the cords can damage its internal wiring. But when hunting down the headphones pulling it by the cords will reason stress on where the cord meets the plug. Over the time, pulling the headphone cords can reason internal wires to break and damage the headphone jack as well.
Sleeping while they are on:
Plugging the headphones in ears while slumbering is neither just right for your health nor for your headphones. You cant control your movements in sleep. Sometimes you roll around, flop approximately, twist and switch that causes heavy damage to your headphones while you sleep with a heavy head. So skip the headphones and hear whatever you are listening to speakers. And if thats not an option and it's essential sleep with the music on, then you can purchase Bluetooth headphones available in the market.
You can see most of the problems above are because of the long cords associated with the headphones. Hence, it is consistently better to go cordless. Just, eliminate the cord from the equation altogether and your headphones will probably last a lot longer with no greater efforts. Go wireless nowadays.